There are some things you can do when having a 100% custom kitchen built – assuming you’re working with the Rod Tidwell cabinet shop. Two of those are "what to do with the space under the kitchen sink?" and "how to hid the dishwasher?"

The typical solution under the kitchen sink is to install a set of doors and just hide everything. However, if you want some organization and you are installing drawers in all of your base cabinets, you might consider a split drawer design. The idea is to install two narrow drawers that fit to either side of the plumbing. In my case, I designed the plumbing under the sink to all line up front to back and thus maximize the available space to either side. In keeping with the look of the other cabinets, I wanted a single drawer front. As you can see in the photos, the large drawer front is attached to two narrow drawers.There is plenty of drawer space and it still leaves clearance for the plumbing.

Concealing the dishwasher is personal choice. Some people want the front to match the cabinets while others want it to match the appliances. There are special dishwashers with unfinished fronts designed to take a custom panel. This may seem strait forward but there are some caveats. Not all panel designs will match up to the dishwasher attachments points. I would go further to say *most* cabinet designs will require the installer to get creative. For example, to insure clearance when opening the dishwasher, the bottom of the panel front was beveled on the back side and the supplied metal cover was lowered.  The larger issue will the the handles. The dishwasher requires a reasonable amount of force to release the spring loaded catch when opening. The typical panel front dishwasher does not allow for pull hardware that mounts from the back; however hardware that mounts to the front is weaker. Add that a panel front (rails, stiles, and a panel in the middle) has only a thin layer of wood for the hardware attach points. All this is to say that you might experience some additional costs from your cabinet installer or some grumblings or a less than perfect job … hopefully not all three and ideally none at all. My solution was to two fold. First, I used a urethane glue and add a filler band of thin material to the back of the panel where the hardware would install. Note: The material must not extend beyond the back side of the rails and stiles holding the panel. Second, after pre-drilling the panel for the bin-pull hardware, I used a slightly smaller bit and predrilled into the metal face skin of the dishwasher. Note: Be careful to just penetrate the metal so as not to hit anything that might be inside.

After installing the panel to the dishwasher front, I then installed the pull hardware with the screws now having a good "bite" into the panel, the filler band, and the face skin of the dishwasher.